Nov 11, 2006 · But when we put the big block in, there wasn't much of a drop in the front end at all even with the weight difference. And I have a stock spindles from a 70 Chevelle in front. I would like to put some nice 16" or 17" wheels in the front with the fender well covering up a part of the wheel to give it the dropped look.

Jul 20, 2023 · Below are the numbers I achieved with my DIY alignment using GW tubular uppers control arms (with .5 taller ball joints) and stock lower control arms, stock front springs @ stock ride height on my 3rd gen Nova (same front end as 1st gen Camaro). Drivers Side - .4° camber / +5.2° Caster / 1/32" toe in Passenger Side

Jun 8, 1999 · If your Camaro is a non-original RS you can easily switch back to the Standard Grill. You won't need any support brackets, you'll actually have to remove the support brackets that are needed for the RS headlamp housing in a non-original RS (This is because a real RS has different front fenders, but yours is not original and I assume you have the standard fenders).

Nov 21, 2012 · First I put 1/8" of shim in the front and 1/4" in the rear of each a-arm cross shaft, just a guess to get it close. Then loaded the car up on the leveling stands and used 2 pieces of floor tile with light weight grease between them to allow the front wheels to move. The greasy floor tiles isn't optimal but for now that's the best I have.

Jun 2, 2008 · Typical 69 front end weight?? Jump to Latest 5.2K views 1 reply 2 participants last post by 40Coupe Jun 2, 2008

Apr 27, 2009 · Stainless steel front end bolt kit 1967 - 69 Camaro Parts Used 69 Camaro front sheet metal 500.00 for everything or fenders 185.00 each fender extensions 30.00 each header panel 60.00 lower valance 50.00 cowl vent panel 35.00 69 RS Fender brackets ORIGINAL 25.00 for both 69 RS outer door cover and backing plate 25.00 for both 69 RS bucket ...

Jun 18, 2008 · 69 Camaro -originally a LM1 car. 327, Edelbrock E-streets, hooker, DUI performance distributors, ultradyne cam, stewart, TRW etc. Vintage Air, AGR steering, Corbeau GTSII seats, 700R4 transmission, 12-bolt w/Eaton 4.11:1

Oct 10, 2000 · I have a 69 Camaro with 31 year old front springs. I have been told that 31 year old springs are definately going to be worn out. I am planning on replaceing the original rubber bushings with polygraphite ones and I figure that would be the time to put in new springs. I was told that TRW makes the best replacement springs for fit and quality.

May 2, 2020 · I suspect the PO lowered the back but still looks like stock springs in front. It looks like the car is always under accelleration, in fact I think that is why the drivers door wont stay open, because of the reverse rake. Wouldnt mind dropping the front 1 …

Nov 3, 2024 · I want to change the emblems to something other than the Z28. The problem is the Z28 emblem has three mounting holes. Can anyone recommend a fender emblem/sorce that will cover these holes. Adhesion emblems would be ok. The location of this emblem is the front end of the fender where the engine displacement usually goes. Thanks.