If you’re reading this and thinking, ‘What is boiler flow temperature?’ you’re not alone. But while most people don’t know what it is, most heating experts would agree that it’s one of the most ...

Combi boilers come with either one or two "flow" temperature dials, for hot water and heating. These buttons adjust the temperature of the water that goes into your radiators or taps. But ...

Adjusting your boiler flow temperature can save up to £57 a year on your gas bills - but turning it down too low can be dangerous. If you aren't sure what your boiler flow temperature setting is ...

Experts from Path Energy said: "Many boilers run hotter than necessary. Setting the boiler flow temperature to a moderate 60C can make your system more efficient without sacrificing your home’s ...

Reduce the flow rate on your boiler A simple tweak to your combination boiler settings could save you money. Boilers have a flow temperature – the level they heat radiators to. These work more ...

Average bills could go down by as much as 9 per cent by turning your boiler flow temperature down, British Gas, OVO, EDF, EON Next and Octopus customers have been told. Ben Gallizzi, energy expert ...

Figure 5 shows schematic diagrams of the 1/10 and 1/20 scale cold models ... MCR Maximum Continuous Rating (%) ṁb mass flow of solids in the boiler (kg/s) ṁm mass flow of solids in the cold model ...

Modern condensing combi boilers can be warmed sufficiently with heating flow temperatures of 60°C–65°C or lower. But many aren't running as efficiently as they could, because their factory default ...

If you aren't using your boiler efficiently, your home is more expensive to heat – see how flow temperature can make a difference to your gas bill Finding simple solutions to cutting your heating ...

provides the accurate air/gas flow measurements needed to optimize boiler performance in order to reduce expensive fuel gas consumption costs and polluting greenhouse waste gases. To operate a ...

When replacing a conventional boiler with a condensing boiler, it’s important to look at the existing system piping. Is the existing system a full-flow or primary/secondary layout? In terms of flow ...